 |
| Purchase Information |
| Use this form to request purchase information on ORG online subscriptions. |
|
|
Document ASTM D 1149 is offered by IHS as part of an online subscription. This subscription contains many documents on the same topic.
You may also purchase this document alone from the IHS Standards Store.
ASTM D 1149 Document Information:
Title
Standard Test Methods for Rubber Deterioration—Cracking in an Ozone Controlled Environment
ASTM International
Publication Date:
Aug 15, 2007
Scope:
These test methods are used to estimate the effect of exposure,
under surface tensile strain conditions, either dynamic or static,
in an atmosphere containing specified levels of ozone
concentration, expressed as partial pressure (refer to Note 1), on
vulcanized rubber, rubber compounds, molded or extruded soft
rubber, and other specified materials, or as may be determined
empirically. The effect of naturally occurring sunlight or light
from artificial sources is excluded.
Previously published ASTM documents Test Method D 518 and Test
Methods D 3395 have been included in these test methods, D 1149, in
2007. Please refer to Note 2.
Test Method D 518 and Test Methods D 3395 have henceforth been
withdrawn and superseded by Test Methods D 1149. When Test Methods
D 1149 is cited, or otherwise referenced, a notation shall be
included to this effect. Please refer to section 3.2 for the
appropriate references.
The specified conditions of exposure to ozone in the controlled
environments are accelerated in comparison to outdoor exposure.
These accelerated ozone test methods may not give results which
correlate with outdoor exposure tests or service performance.
All materials, instruments, or equipment used for the
determination of mass, force, dimension, ozone concentration,
partial pressure, temperature, velocity, and gas exchange rate
shall have direct traceability to the National Institute for
Standards and Technology, or other internationally recognized
organization parallel in nature.
The values stated in SI units are to be regarded as standard.
The values given in parentheses are for information only. Many of
the stated SI units are direct conversions from the U.S. Customary
System to accommodate the instrumentation, practices, and
procedures that existed prior to the Metric Conversion Act of
1975.
This standard involves hazardous materials, specifically
ozone. It may also involve hazardous operations and
equipment. This standard does not purport to address all of
the safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish
appropriate safety and health practices and determine the
applicability of regulatory limitations prior to use.
NOTE 1—A discussion and explanation regarding the measurement of
ozone concentrations based upon parts of ozone per unit of air
versus partial pressure is provided in Test Methods D 4575,
specifically Appendices X1 and X2. Test Methods D 4575 is also
recommended as a source of background information regarding
standards involving materials exposed to ozone.
Keywords:
- chamber
- cracking
- deterioration
- ozone
- rubber
- surface
- test
About IHS
IHS (NYSE: IHS) is a leading global provider of critical technical information, decision-support tools and related services in a number of industries including aerospace and defense, automotive, construction, electronics, and energy. IHS serves customers ranging from large governments and multinational corporations to smaller companies and technical professionals in more than 100 countries. IHS been in business for more than 45 years and employ more than 2,300 people around the world.
