ASTM A775/A775M REV B: Standard Specification for Epoxy-Coated Steel Reinforcing Bars
DOD Adopted ANSI Approved Approved
This specification covers deformed and plain steel reinforcing bars with protective epoxy coating applied by the electrostatic spray method.
NOTE 1-The coating applicator is identified throughout this specification as the manufacturer.
Other organic coatings may be used provided they meet the requirements of this specification.
Requirements for coatings are contained in Annex A1.
Requirements for patching material are contained in Annex A2.
Guidelines for construction practices at the job-site are presented in Appendix X1.
This specification is applicable for orders in either SI units (as Specification A775M) or inch-pound units [as Specification A775].
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Buy this Standard Now
Or if you answer yes to any of these questions:
- Do you purchase more than $3000 in standards per year?
- Do you purchase many different kinds of standards?
- Do you have multiple employees accessing the same standards?
You may save money by purchasing more comprehensive online access.
* Required field