ASTM D 2143 Standard Test Method for Cyclic Pressure Strength of Reinforced, Thermosetting Plastic Pipe
 |
| Purchase Information |
| Use this form to request purchase information on ASTM online subscriptions. |
|
|
Document ASTM D 2143 is offered by IHS as part of an online subscription. This subscription contains many documents on the same topic.
You may also purchase this document alone from the IHS Standards Store.
ASTM D 2143 Document Information:
Title
Standard Test Method for Cyclic Pressure Strength of Reinforced, Thermosetting Plastic Pipe
ASTM International
Publication Date:
Nov 10, 2000
Scope:
(Footnote *)
This test method covers the determination of the failure
characteristics of reinforced plastic pipe
when subjected to cyclic internal hydraulic pressure. It is limited to
pipe in which the ratio of
outside diameter to wall thickness is 10:1 or more.
The values stated in inch-pound units are to be regarded as the
standard. The values in parentheses
are for information only.
This standard does not purport to address all of the safety concerns,
if any, associated with its
use. It is the responsibility of the user of this standard to
establish appropriate safety and
health practices and determine the applicability of regulatory
limitations prior to use.
NOTE 1 - There is no similar or equivalent ISO standard.
Footnote * - A Summary of Changes section appears at the end of this
standard.
Keywords:
- fiberglass pipe
- hydrostatic design basis
- pressure design basis
- cyclic pressure strength
About IHS
IHS (NYSE: IHS) is a leading global provider of critical technical information, decision-support tools and related services in a number of industries including aerospace and defense, automotive, construction, electronics, and energy. IHS serves customers ranging from large governments and multinational corporations to smaller companies and technical professionals in more than 100 countries. IHS been in business for more than 45 years and employ more than 2,300 people around the world.
