BSI BS EN 10034: Structural Steel I and H Sections - Tolerances on Shape and Dimensions
SDO: BSI: British Standards Institution
DOD Adopted ANSI Approved Approved
This European Standard specifies tolerances on shape dimensions and mass of structural steel I and H sections. These requirements do not apply to I and H sections rolled from stainless steel. These requirements do not apply to taper flange sections.
NOTE Until a European Standard for dimensions of I and H beams is published Euronorm19 and Euronorm 53 or corresponding national standards may be used.
- Structural steels
- Metal sections
- Straightness measurement
- Sections (structures)
- Structural members
- Dimensional tolerances
- Form tolerances
Buy this Standard Now
Or if you answer yes to any of these questions:
- Do you purchase more than $3000 in standards per year?
- Do you purchase many different kinds of standards?
- Do you have multiple employees accessing the same standards?
You may save money by purchasing more comprehensive online access.
* Required field