ASTM D3382: Standard Test Methods for Measurement of Energy and Integrated Charge Transfer Due to Partial Discharges (Corona) Using Bridge Techniques
SDO: ASTM: ASTM International
DOD Adopted ANSI Approved Approved
These test methods cover two bridge techniques for measuring the energy and integrated charge of pulse and pseudoglow partial discharges:
Test Method A makes use of capacitance and loss characteristics such as measured by the transformer ratio-arm bridge or the high-voltage Schering bridge (Test Methods D 150). Test Method A can be used to obtain the integrated charge transfer and energy loss due to partial discharges in a dielectric from the measured increase in capacitance and tan d with voltage. (See also IEEE 286 and IEEE 1434)
Test Method B makes use of a somewhat different bridge circuit, identified as a charge-voltage-trace (parallelogram) technique, which indicates directly on an oscilloscope the integrated charge transfer and the magnitude of the energy loss due to partial discharges.
Both test methods are intended to supplement the measurement and detection of pulse-type partial discharges as covered by Test Method D 1868, by measuring the sum of both pulse and pseudoglow discharges per cycle in terms of their charge and energy.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precaution statements are given in Section 7.
*A Summary of Changes section appears at the end of this standard.
- bridge circuits
- bridge techniques
- capacitance increase
- charge-voltage-trace bridge
- discharge energy
- discharge inception level
- integrated charge transfer
- internal discharges
- ionizing voltage
- loop trace
- partial discharges
- pseudoglow discharge
- pulse discharge
- pulseless-glow discharge
- pulse measurements
- solid insulating materials
- surface discharge
- transformer-ratio-arm bridge
Buy this Standard Now
Or if you answer yes to any of these questions:
- Do you purchase more than $3000 in standards per year?
- Do you purchase many different kinds of standards?
- Do you have multiple employees accessing the same standards?
You may save money by purchasing more comprehensive online access.
* Required field