 |
| Purchase Information |
| Use this form to request purchase information on ASTM online subscriptions. |
|
|
Document ASTM A 635/A 635M is offered by IHS as part of an online subscription. This subscription contains many documents on the same topic.
You may also purchase this document alone from the IHS Standards Store.
ASTM A 635/A 635M Document Information:
Title
Standard Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, and High- Strength Low-Alloy with Improved Formability, General Requirements for
ASTM International
Publication Date:
Sep 1, 2007
Scope:
This specification covers the general requirements for
hot-rolled, heavy-thickness sheet and strip in coils.
It applies to Specification A 1018/A 1018M.
NOTE 1—The changes in width limits with the publication of A
635/A 635M – 06a result in a change in tensile testing direction
for material from 0.180 in. [4.5 mm] to 0.230 in. exclusive [6.0 mm
exclusive] over 48 in. [1200 mm] wide as that material is now
covered by Specification A 568/A 568M – 06a. The purchaser is
advised to discuss this change with the supplier.
In case of any conflict in requirements, the requirements of the
individual material specification shall prevail over those of this
general specification.
Annex A1 lists permissible variations in dimensions and mass
(see Note 2) in SI [metric] units. The values listed are not exact
conversions of the values listed in the inch-pound tables, but
instead are rounded or rationalized values. Conformance to Annex A1
is mandatory when the "M" specification is used.
NOTE 2—The term weight is used when inch-pound units
are the standard. However, under SI, the preferred term is
mass.
The values stated in either inch-pound units or SI units are to
be regarded as standard. Within the text, the SI units are shown in
brackets. The values stated in each system are not exact
equivalents; therefore, each system must be used independently of
the other. Combining values from the two systems may result in
nonconformance with this specification.
This specification and the applicable material specifications
are expressed in both inch-pound units and SI units. However,
unless the order specifies the applicable "M" specification
designation (SI units), the material shall be furnished to
inch-pound units.
*A Summary of Changes section appears at the end of this
standard.
Keywords:
- carbon
- commercial
- drawing
- heavy thickness coils
- high-strength low-alloy
- high-strength low-alloy with improved formability
- sheet steel
- strip steel
About IHS
IHS (NYSE: IHS) is a leading global provider of critical technical information, decision-support tools and related services in a number of industries including aerospace and defense, automotive, construction, electronics, and energy. IHS serves customers ranging from large governments and multinational corporations to smaller companies and technical professionals in more than 100 countries. IHS been in business for more than 45 years and employ more than 2,300 people around the world.
