ASTM A1011/A1011M: Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High- Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength
SDO: ASTM: ASTM International
DOD Adopted ANSI Approved Approved
This specification covers hot-rolled, carbon, structural, high-strength low-alloy, high-strength low-alloy with improved formability, and ultra-high strength steel sheet and strip, in coils and cut lengths.
Hot rolled steel sheet and strip is available in the designations as listed in 4.1.
This specification is not applicable to the steel covered by Specification A635/A635M.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
*A Summary of Changes section appears at the end of this standard
- carbon steel sheet
- carbon steel strip
- commercial steel
- drawing steel
- high strength-low alloy steel
- high strength-low alloy steel with improved formability
- hot-rolled steel sheet
- hot-rolled steel strip
- steel sheet
- steel strip
- structural steel
- ultra-high strength steel
Buy this Standard Now
Or if you answer yes to any of these questions:
- Do you purchase more than $3000 in standards per year?
- Do you purchase many different kinds of standards?
- Do you have multiple employees accessing the same standards?
You may save money by purchasing more comprehensive online access.
* Required field